PCI Oversized SRB Series Split Repair with Band Clamp Fittings restore watertight seals around existing piping and conduit penetrations. The larger profile is designed to eliminate the need to pair a standard SRB fitting with a separate BSO fitting in applicable repairs.

Built from 100% fiberglass and compatible with double wall containment systems, the Oversized SRB combines an 8-inch outside diameter with a split design for installation around existing lines.

Double Wall Compatible

Oversized SRB fittings are compatible with double wall containment systems.

Larger Repair Profile

The 8-inch outside diameter provides a larger bonding footprint at the sump wall, offering an alternative to a separate SRB and BSO combination where installation conditions allow.

Split Design for Repairs

The fitting assembles around existing piping or conduit, simplifying replacement of damaged or deteriorated penetration boots.

Band Clamp with Retention Rim

A stainless steel band clamp holds the fitting together while the epoxy cures. The retention rim prevents the clamp from sliding off during installation.

Misalignment Flexibility

Oversized SRB fittings accommodate angled pipe entries up to 20 degrees, providing flexibility when repairing existing penetrations.

Fiberglass Sleeve for Flex Pipe

Flex pipe models include a fiberglass sleeve. Bonded to polyethylene piping with PCI’s Clear Magic adhesive, the sleeve provides a fiberglass surface for bonding the repair fitting.

100% Fiberglass Construction

Corrosion-resistant fiberglass provides strength and a durable alternative to rubber or plastic penetration boots, supporting long-term performance during fuel exposure, including ethanol.

Field-Modifiable Design

Oversized SRB fittings can be modified in the field to simplify service work. Follow PCI’s installation guidance for modifications and bonding requirements.

Permanent Bonding Options

• EP2A: Two-part epoxy for bonding fiberglass fittings to fiberglass and steel, with gap-filling capability and sag resistance.
• Clear Magic: PCI’s proprietary three-part adhesive for permanently bonding fiberglass to polyethylene.

Conduit and Piping Compatibility

Available flat-wall models accommodate:

• Galvanized conduit: 3/4-inch and 1-inch
• RTIIA piping: 2-inch, 3-inch, and 4-inch
• LCX piping: 2-inch, 3-inch, and 4-inch
• Flex pipe: 1.5-inch, 2-inch, and 2.5-inch outside diameters

UL® 2447 Listed

Oversized SRB fittings are UL® 2447 Listed for use in applicable containment installations.

Specifications and Installation Resources

Download the product brochure and installation instructions for part numbers, fitting dimensions, piping compatibility, surface preparation, and bonding requirements.

Long-Term Solution

100% fiberglass construction provides superior strength and ensures the fitting will withstand long-term exposure to all fuels, including ethanol.

Allows for Misalignment

Works with angled pipe entries up to 20° for job site adaptability allowing room for misalignment.

Cost-Effective

PCI’s penetration fittings are the most affordable fiberglass fittings on the market, with a similar cost to rubber or plastic fittings.

EP2A – Epoxy Bonding

EP2A is two-part epoxy available to bond fiberglass penetration fittings to fiberglass and steel. Due to its thickened consistency, It has great gap filling properties and excellent sag resistance, making it a simple and dependable bonding solution.

Clear Magic – Bonds Fiberglass to Polyethelyene

Clear Magic, PCI’s proprietary three-part adhesive, can be used with any of our fiberglass fittings to permanently bond fiberglass to polyethylene.

Brochure

Installation Instructions

UL® Listed 2447

California Code of Regulation Title 23, Division 3, Chapter 16, Section 2631 (AB 2481/ California VPH)

State of Florida Department of Environmental Protection Approved / Registered Storage Tank System: EQ-203